Not running the full code

Submitted by JMonte57 on Mon, 07/09/2018 - 10:42

Hi Newbie here
I am working on a code where when the device is power up and it is not home the DMC while home it sself. that part is working great. I written another just to move all three axis and then return to the start position. I now combine the two to see after it homes it will start motion. The unit will home but then nothing happens. here is the practice code I did not sure what I am missing.

#AUTO
SB 5 ' engage power
HM
FE
SP 10000,10000,10000
AC 500000,500000,500000
DC 500000,500000,500000
BG
AM
DP 0000000000,0000000000,0000000000
TP
EN

#MOVE
PA 40000,20000,2 0000
SP 40000,40000,30000
AC 500000,500000,500000
DC 500000,500000,500000
BGX
AMX
BGY
AMY
BGZ
AMZ
TP
TS
WT 2500
PA 0,0,0
BGX
AMX
BGY
AMY
BGZ
AMZ
TP
TS
EN
any help would be great
Thanks
JJ

Comments 1

JMonte57 on 07/09/2018 - 10:46

figured it out. I removed the en in the first part and removed the lable on the second part my bad.

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.